![]() However, outputs are now powered all the time, they don't follow TC+ setting. I have set output type to Spare / Lighning / Toggle / Reflex, because there's no fundamental need to control them based on zones. I have partially correct configuration, since TC+ now sees outputs in lightning section and they can be toggled. ![]() If problem is caused by shielding, should it be connected at both ends (panel, distribution board), or only single end (which one)?Īnd final question, I want to control lightning with TC+. Clear wire is connected on Cat6 between all the runs, haven't connected the shielding to anything, can it cause problem like this? If this is power-problem, I can supply ground level devices from separate power supply with battery backup used for smoke detectors, it has enoguh spare capacity. I have already tried with two different TC+, always same problem. The weird thing, mk8 keyboard has communication quality of 100% and it's last device on bus after TouchCenter Plus. Picture of all devices and bus topology attached. ![]() There's one Krone-row connector (located in main distribution board), where pairs are connected, pairs are correct, twisting has been preserved and topology is definitely bus, not star or something else. Total bus length is between 20m and 30m, closer to 20m I think. Both ends have 680Ohm resistors and power supply is from panel. There's short (about 20cm) internal run of untwisted 4-wire between panel and Ethernet module inside panel enclosure, this wire came with ethernet-module. Cabling is Cat5 unshielded/ Cat6 shielded, last part to mk8 keyboard is 2-pair shielded Belden. Keyboard diagnostics give connection quality varying between 0% and 100%. I'm having frequent (couple times a day) keyboard lost-problem with TouchCenter Plus connected to GD-48 (firmware 7.something). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |